Your browser does not have the flash player plug-in, you need to get it from www.flash.com 
Introduction   |   Residential Streets   |   Collector Streets   |   Rural Roads   |   Arterials & Highways
Parking Lots   |    Residential Driveways   |   Pathways   |   Recreational Facilities 
Heavy Industrial Facilities   |   Airfields   |   Site Paving   |   References
 

 

References

Suggested Reading

Specific recommended references are contained on each design catalog page - these are general design catalog references.

American Association of State Highway and Transportation Officials (AASHTO).  (1993).  AASHTO Guide for Design of Pavement Structures.  American Association of State Highway and Transportation Officials.  Washington, D.C.

The Asphalt Institute.  (no date given).  Asphalt Overlays for Highway and Street Rehabilitation, Information Series No. 181.  The Asphalt Institute.  Lexington, KY.

The Asphalt Institute.  (1992).  Model Construction Specifications for Asphalt Concrete and Other Plant-Mix Types, Specification Series No. 1.  The Asphalt Institute.  Lexington, KY.

The Asphalt Institute.  (1999).  Thickness Design - Asphalt, Manual Series No. 1.  The Asphalt Institute.  Lexington, KY.

The Asphalt Institute.  (2001).  Construction Specifications for Asphalt Curbs and Gutters, Specification Series No. 3.  The Asphalt Institute.  Lexington, KY.

Publications Cited in this Section

Asphalt Paving Association of Iowa (APAI).  (no date given).  Asphalt Paving Design Guide APAI.  West Des Moines, IA.  Available at: http://www.apai.net.

Colorado Asphalt Pavement Association (CAPA).  (2000).  Guideline for the Design and Use of Asphalt Pavements for Colorado Roadways.  CAPA.  Englewood, CO.

Asphalt Pavement Association of Oregon (APAO).  (1998).  Asphalt Paving Design Guide.  APAO.  Salem, OR.  Available at: http://www.apao.org.

National Asphalt Pavement Association (NAPA).  (2002).  Design, Construction, and Performance of Heavy Duty Mixes, Quality Improvement Series 123.  National Asphalt Pavement Association.  Landham, MD. 

Rapol, Jeff. (2001).  Memorandum from Jeff Rapol to Jack Scott regarding an initial review of a report entitled: A Quantification and Evaluation of WSDOT’s Hot Mix Asphalt Concrete Statistical Acceptance Specification.  (Subject: Washington State DOT HMA Statistical Acceptance Specifications) dated 6/26/01. Received by facsimile from Jack Scott on 29 June 2001.

Texas Transportation Institute (TTI).  (1997).  Design and Evaluation of Large-Stone Asphalt Mixes.  Texas A&M University, National Cooperative Highway Research Program Report 386, Transportation Research Board, National Research Council.  Washington, D.C.
 

 

t Previous Top  Next u

© 2002, Washington Asphalt Pavement Association, Inc.  (disclaimer, credits)